Connect Ethernet - GE LOGIQ E9 Service Manual

GE
D 5573152-100, R
IRECTION
3-6-4-1

Connect Ethernet

Connect the Ethernet cable to the Ethernet connector (3) on the External I/O (rear side of LOGIQ E9).
Figure 3-13 Audio (1), Ethernet (2), DVI-I (3) and SVHS (4) connection for External Monitor on
rear side of LOGIQ E9
To avoid breaking the back cover while opening it in order to connect up the network cable, use
CAUTION
a flat blade screw driver or plastic card and pull hard to open up the back cover door.
SVHS Specifications for BEP6
• DVI-I delivering both analog RGB and digital DVI out the rear customer accessible DVI-I port.
• The DVI-I output support a fixed 1280x1024 resolution @60Hz 24 bit color depth.
-
• The DVI-D Video output deliver a minimum of 1280x1024 @60Hz 24-bit color depth.
3-6-4-2 Connect USB Flash Drive
Refer to the current revision of the LOGIQ E9 Basic User Manual, Chapter 3, Section 7.
3 - 20
. 2
EV
2
L R
1
NOTE: Any display connected to the DVI-I output is intended to serve as a clone of the image
on the main display. In the event that a display connected to DVI-I video output is not capable
of displaying the resolution being used by the main display, then the auxiliary display will be
blank or show a "no-signal" message.
Section 3-6 - Completing the setup
4 3
2 1
4 3
LOGIQ E9 S M
ERVICE ANUAL