Rear Bumper Replacement - GE LOGIQ E9 Service Manual

GE
D 5573152-100, R
IRECTION
8-5-15

Rear Bumper replacement

8-5-15-1 Manpower
One person, 15 minutes.
8-5-15-2 Tools
For tools needed, refer to:
8-5-15-3 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the system
2.) Disconnect the mains power cable from the wall outlet.
3.) Disconnect all Probes and External I/O Cabling.
4.) Remove Side Covers.
5.) Remove Rear Cover.
Follow these links if you need more information:
• 4-2-3 "Power shut down" on page 4-6.
• 8-5-3 "Side Covers replacement" on page 8-28.
• 8-5-12 "Rear Cover replacement" on page 8-51.
8-5-15-4 Rear Bumper removal
1.) Remove the two screws securing the Rear Bumper.
2.) Remove Bumper.
8-5-15-5 Rear Bumper installation
1.) Place the Rear Bumper into position
2.) Install the two screws to secure the Rear Bumper.
. 2
EV
8-2-5 "Tools needed for servicing the LOGIQ E9" on page
Figure 8-21 Left screw placement for Rear Bumper
Chapter 8 Replacement procedures
LOGIQ E9 S M
ERVICE ANUAL
8-5.
8 - 61