GE LOGIQ E9 Service Manual page 373

GE
D 5573152-100, R
IRECTION
8-6-2-2 LCD Monitor installation - R3.x and earlier
Table 8-60
1.
NOTE: To ensure the LCD Monitor is
installed level with the system and before
tightening the four screws:
MAKE SURE:
- the system is on a level surface,
- the wheels are in-line,
- the LCD Monitor Arm Lock is LOCKED.
Check that the system is level.
Install the LCD Monitor assembly on the
Monitor Bracket. Verify that all four fixing
screws have engaged in their slots.
Place a level on the monitor (as shown).
Tighten the four screws, torque: 160 Ncm
{14.2 lbf-in}).
NOTE: If a level is not available, make sure
the Monitor is as square as possible with
the system, visually.
2.
Tilt the monitor to horizontal position.
Connect the cables (1).
If the cables were replaced the tie-wraps
(2) and cable clamps (3), if present.
Re-install WLAN dongle, if device is
equipped with option.
NOTE: It is important to reapply a piece of
the "loop" portion of Velcro to the WLAN
dongle when it is re-installed into the new
monitor.
. 2
EV
LCD Monitor installation - R3.x and earlier
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
LCD Monitor Cables and Clamps
M
ERVICE ANUAL
8 - 89