Connecting The Black & White Printer - GE Voluson E8 Service Manual

GE H DRAFT
EALTHCARE
D KTD102576, R
IRECTION
3-5-2 Connecting the Black & White Printer
1.) Power OFF/Shutdown the system as described in:
2.) Connect the Black & White printer according to connection scheme, see:
NOTE: The B&W printer should be connected to the USB3 port of the Voluson E8 / Voluson E6´s PC-part.
Location of the USB3 port depends on the installed PC-Motherboard.
3.) When all the cables are connected, press the Power ON switch on the Black & White printer.
4.) Power ON/Boot up the Voluson E8 / Voluson E6 system as described in
31. All software drivers are pre-installed for the designated Black & White printer only.
Please
If the printer driver for the Mitsubishi P95D B&W printer is not pre-installed, install it manually by means
Note
of the "Found New Hardware Wizard" and the printer driver disk which is included with this new printer.
5.) After physical connection to the Voluson E8 / Voluson E6 system, assign the printer to a remote key
(P1, P2, P3 and/or P4) as described in
6.) Verify the correct settings in the printer "Properties", see:
Settings" on page
After each installation, the leakage currents have to be measured according to
WARNING WARNING
IEC 60601-1 respectively UL 60601-1.
!! WARNING:
7 DRAFT (A
EVISION
3-41.
Chapter 3 - Setup Instructions
23, 2012)
UGUST
Section 3-6-3 on page
Section 3-7-5 "Remote Control Selection" on page
Section 3-7-4 "Adjustment of Printer
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
3-34.
Figure 3-6 on page 3-12.
Section 3-6-2 on page 3-
3-48.
3-11
E6