Power Off / Shutdown; Scanner Shutdown - GE Voluson E8 Service Manual

GE H RAFT
EALTHCARE
D KTD102576, R
IRECTION
3-6-3

Power Off / Shutdown

NOTICE
After turning off a system, wait at least 10 seconds before turning it on again.
The system may not be able to boot if power is recycled too quickly.
!! NOTICE:
3-6-3-1

Scanner Shutdown

1.) If not already in read mode, freeze the image.
2.) Press the ON/OFF Standby button
3.) Select the SHUTDOWN button. The system performs an automatic full shutdown sequence.
NOTE: Full shut down is also performed when pressing the ON/OFF Standby button on the control panel twice.
4.) Switch OFF the Circuit Breaker at the rear of the system.
NOTE: The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the
ON/OFF Standby button. So the auxiliary equipment need not to be switched ON/OFF separately.
WARNING WARNING Disconnection of the Main Power Cable is necessary!
For Example: When repairing the system.
!! WARNING:
5.) After complete power down, unscrew the 2 screws and remove the pull-out protection to disconnect
the main power cable from the system or unplug it from the AC wall outlet socket.
Circuit Breaker
pull-out protection
1 screw
Main Power Cable
Figure 3-30 Circuit Breaker, pull-out protection and main power cable at rear of system
6.) Press on the brakes to block the front caster wheels.
7.) Disconnect probes. (Turn the probe locking handle counterclockwise and then pull the connector
straight out of the probe port.)
DO NOT disconnect a probe while running (Live Scan "Write" mode)!
CAUTION
A software error may occur. In this case switch the system OFF (perform a reset).
!! CAUTION:
3-34
7 DRAFT (A
EVISION
Figure 3-29 Shutdown, Restart or Cancel
Section 3-6 - Completing the Set Up
23, 2012)
UGUST
(Figure 3-26) on the control panel. Following dialog appears.
V E8 / V
OLUSON OLUSON
S M
ERVICE ANUAL
1 screw
E6