Sony PMW-PZ1 Service Manual page 70

3. Remove the CPU board (COMe module).
(1) Remove the four supports (M2,L4).
(2) Remove the CPU board (COMe module) from the two connectors (CN6001, CN6002) on the HPR-56 board.
Note
When installing the CPU board (COMe module), confirm that the connectors are fully inserted. In that case,
connector pins of the CPU board (COMe module) are hidden by the connector on the HPR-56 board.
(3) Remove the four COM support shafts.
Supports (M2, L4)
(Tightening torque ：
0.20 ±0.02 N·m)
COM support shaft
(Tightening torque ：
0.53 ±0.07 N·m)
HPR-56 board
4. Install the removed parts by reversing the steps of removal.
PMW-PZ1
CPU board
(COMe module)
J5
J6
CN6002 CN6001
CPU board
(COMe module)
Connectors of the HPR-56 board
(CN6001， CN6002)
Connectors are fully inserted
Connectors are incompletely inserted
Connector(J5， J6)
Contacts of the
connector (J5， J6)
Contacts of the
connector (J5， J6)
5-26