Ky-740 Board - Sony PMW-PZ1 Service Manual

5-4.

KY-740 Board

Preparation
1. Remove the top panel. (Refer to
2. Remove the front panel assembly. (Refer to
Procedure
1. Disconnect the cables and harness.
(1) Open the clamper, then release the three fine-wire coaxial cables and harness.
(2) Disconnect the fine-wire coaxial cable from the connector (CN101) on the KY-740 board.
Harness KY-740 board
Fine-wire coaxial cables
2. Remove the five screws, and remove the KY-740 board.
(b)
PSW2 x 5
Reference hole
KY-740 board
Boss
Note
When installing the KY-740 board, observe the following instructions.
• Align the boss on the front frame with the reference hole of the KY-740 board.
• Tighten the screws in the following sequence: (a), (b), (c), (d), (e).
PMW-PZ1
"5-2. Top Panel")
"5-3. Front Panel
Clamper
CN101
Fine-wire coaxial cable
(a)
PSW2 x 5
(e)
PSW2 x 5
(c)
PSW2 x 5
(d)
PSW2 x 5
Knob
Assembly")
Front frame
5-6