Sony PMW-PZ1 Service Manual page 65

5. Install the front chassis assembly.
(1) Install the front chassis assembly and temporarily tighten the screw (a).
(2) Tighten the screw (b).
(3) Connect the harness to the connector (CN5601) on the HPR-56 board.
Front chassis assembly
Harness
6. Tighten the screw (BTP3 x 8), the screw (B3 x 4), and the two screws (B2.6 x 5).
Note
Tighten the screws in the following sequence: (a), (b), (c), (d).
PMW-PZ1
(b)
PSW3 x 6
(a)
PSW3 x 6
HPR-56 board
CN5601
(d)
BTP3 x 8
(Tightening torque ： 0.85 ±0.05 N·m)
(a)
B2.6 x 5
(b)
B2.6 x 5
(c)
B3 x 4
(Tightening torque ： 0.60 ±0.05 N·m)
5-21