Corporate Addresses - GE CM6 Hardware Reference Manual

Corporate addresses

GE Intelligent Platforms – CM6 Hardware Reference Manual, Fourth Edition
against potential problems. Filtering, optical isolation, ESD gaskets and other
measures might be required at the physical point of entry (enclosure wall of box
or rack). For example it is state-of-the-art that protection can not be done at the
internal connector of an RTM if a cable is attached and routed outside the
enclosure. It has to be done at the physical entry point as specified above.
Products manufactured by GE Intelligent Platforms should normally be suitable
for use in properly designed and produced customer equipment (system boxes
or operational systems) without any major redesign. However, the systems
might be subject to problems and issues once assembled, cabled and used. The
end user, system integrator or installer must test for possible problems and in
some cases show compliance to local regulations as required in his country or
by the intended application.
Regional headquarters
US
Americas & Pacific Rim (Japan,
Korea, China, Philippines, AUS, NZ)
GE Intelligent Platforms, Inc.
2500 Austin Drive
Charlottesville, VA 22911
U.S.A.
Phone: +1-800-322-3616
Fax: +1-
Web: www.ge-ip.com
GE Intelligent Platforms on the Web:
For contact and other information (service, warranty, support etc.) see address
list in chapter: 'Support, Service'.
Corporate headquarters
GE Intelligent Platforms, Inc.
2500 Austin Drive
Charlottesville, VA 22911
U.S.A.
Phone: +1-800-322-3616
Web: www.ge-ip.com
Germany
Germany
GE Intelligent Platforms GmbH &
Co. KG
Memminger Str. 14
86159 Augsburg
Germany
Phone: +49-821-5034-0
Fax:
Email: sales.augsburg.ip@ge.com
http://www.ge-ip.com
+49-821-5034-119
Page 7