Figure 5: Board In Card Cage - GE CM6 Hardware Reference Manual

Initial Power-On Operation
GE Intelligent Platforms – CM6 Hardware Reference Manual, Fourth Edition
When the processor should begin executing initial boot loader resident routines
and when the boot loader is complete the board status LED at the transition
module is switched off.
Please see chapter "Interfaces" for details on onboard interfaces. The location
of the CM6 interfaces is shown on page 33.
After a few seconds, the CM6 system boot message will appear on the terminal
and the status LED is set to green.
If you have seen all the messages so far, you can be confident that the board is
running properly and is ready to be installed and setup for your application.

Figure 5: Board in card cage

Page 31