Unpacking And Inspection; Esd - GE CM6 Hardware Reference Manual

CHAPTER 2
Chapter Scope

ESD

GE Intelligent Platforms – CM6 Hardware Reference Manual, Fourth Edition

Unpacking and Inspection

This chapter covers the suggested inspection and preparation considerations
and background information necessary prior to using the CM6. Unpacking,
initial inspection and first-time operation of the CM6 are covered. Following
the procedures given in this chapter is recommended, since they will verify
proper operation after shipping and before the product is integrated into your
system.
Electrostatic Discharge Notice
The discharge of static electricity, known as Electro Static Discharge or ESD, is
a major cause of electronic component failure. The CM6 has been packed in a
static-safe bag which protects the board from ESD while the board is in the bag.
Before removing the CM6 or any other electronic product from its static-safe
bag, be prepared to handle it in a static-safe environment.
You should wear a properly functioning anti static strap and ensure you are
fully grounded. Any surface upon which you place the unprotected CM6 should
be static-safe, usually facilitated by the use of anti static mats. From the time
the board is removed from the anti static bag until it is in the card cage and
functioning properly, extreme care should be taken to avoid 'zapping' the board
with ESD. You should be aware that you could 'zap' the board without you
knowing it; a small discharge, imperceptible to the eye and touch, can often be
Page 25