Table of Contents
Advertisement
Onboard Pull-up resistors are optimized for 3.3 V I/O voltage, but 5 V I/O can
also be used for 33 MHz
System/non-System
The CM6 board can be used either as system or peripheral board at the cPCI
bus
COP Interfaces
Processor debug interface for external emulator at rear
JTAG Interface
JTAG interface for all devices with JTAG interface accessible at the cPCI
connector
Flash Kill
Optional the user can destroy the Flash devices and its content for security
reasons (contact factory)
Strapping Configurations
Strapping configurations are available from rear
Hardware write-protection for all programmable devices
Software configuration select
Flash kill option
Required Power Voltages
+3.3 V, +5 V
+12 V and -12 V for supply for PMC modules
+12 V for Flash Kill option
Conduction Cooling
Conduction Cooling available
Conformal Coating
The board can optionally be conformal coated to protect against humidity and
fungus devices, configuration selection
LED Indicators
CPU Fail LEDs at rear. Status and user LED at board for debugging
Temperature Sensors
Temperature sensor (LM86) show the temperature of the system board near
CPU and CPU die temperature
CPU voltage is shut-off when die temperature reaches 110 °C or board
temperature reaches 95 °C
Front Panel
Front panel with PMC opening
Backpanel IO
1)
1)
COM1-2, GPIO
, Reset, PMC IO
,
1)
2x Gigabit Ethernet, Boot Select, HW Write Protect, Flash Kill
, COP
Transition module CTM19 available for compatible connectors
1)
depends on PMC IO configuration
GE Intelligent Platforms – CM6 Hardware Reference Manual, Fourth Edition
Page 22
Advertisement
Table of Contents
