Connect Power Cable - Honeywell Thor VM2 Reference Manual

Connect Power Cable

Note: This section assumes the Thor VM2 is mounted in the Quick Mount Smart Dock.
1. Connect the power cable to vehicle power (See
2. The plug and receptacle are keyed and care must be used when connecting the cables. Tighten the nut of the plug
clockwise until tight.
3. Secure the cable with a
4. Press the Power switch on the back of the Thor VM2 dock. Press the side of the power switch with the raised bump to
pass power from the Dock to the Thor VM2.
5. Press the Power button on the front of the Thor VM2 to turn the Thor VM2 on.
Generally, once the Dock is powered On, there is no need to power it off. The Dock power can remain On even when the Thor
VM2 is not attached.
Vehicle 10-60 VDC Power
strain relief cable clamp.
Connection.)
4-15