Procedure - Ram Mount Assembly; Torque Measurement; Step 1A - Attach Ram Ball To Vehicle - Honeywell Thor VM2 Reference Manual

Vehicle-mount computer

Hide thumbs Also See for Thor VM2:

Table of Contents

Procedure - RAM Mount Assembly

Equipment Needed: Sockets, screwdriver and a Torque wrench capable of measuring to 50 inch pounds (5.64±.56 N/m).

Note:

Torquing tool is not supplied by Honeywell. Tools needed to attach the RAM Clamp Mount to the vehicle are not

supplied by Honeywell.

You will need a torquing tool capable of torquing to 20 inch pounds (1.10 N/m). Torque all screws and bolts according to the

following table:

For these nuts...

10-32 lock nuts

Step 1a – Attach RAM Ball to Vehicle

Note:

If you are using the RAM clamp mount, please go to

1c.

1. Determine the position for mounting the RAM ball base. Be sure to position the RAM bracket to allow access to the

switches and ports on the bottom of the Thor VM2.

2. Attach the RAM ball base to the vehicle mounting surface using four 1/4 bolts (or equivalent) fasteners.

Note:

1/4 bolts not included.

IMPORTANT: Mount to the most rigid surface available.

2-4

Torque to

17 - 20 in/lb (0-95 - 1.10 N/m)

Step

1b. If you are using the RAM plate mount, please go to

Step

Table of Contents