Screen Blanking Cable; Optional Honeywell Cable; User-Supplied Cable - Honeywell Thor VM2 Reference Manual

Please refer to the appropriate illustration below for Screen Blanking Box wiring diagrams.
Caution:
Do not exceed the maximum input voltage, either 60 or 72VDC, specified on the Screen Blanking Box label when
using this configuration.
Note: The black and gray wire colors in the illustration only apply to the optional Honeywell Screen Blanking Box Cable,
VM1080CABLE. The wire colors may be different in a user-supplied cable.

Screen Blanking Cable

Optional Honeywell Cable

The optional Honeywell Screen Blanking Box Cable, VM1080CABLE is installed as follows:
1. Connect the gray wire of the cable to the switched side of the Screen Blanking Box.
2. Connect the black wire of the cable to the unswitched side of the Screen Blanking Box.
3. Connect the D9 serial connector to either COM1 or COM2 serial port on the Thor VM2 Quick Mount Smart Dock.

User-Supplied Cable

A user-supplied cable can be used as well. Pins 7 and 8 must be connected as shown in the illustration above. No other pins
are to be connected.
4-12
VM1080CABLE