Strain Relief Cable Clamps - Honeywell Thor VM2 Reference Manual

Strain Relief Cable Clamps

Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are five strain relief cable clamps secured to the Thor VM2 Quick Mount Smart Dock.
Use the strain relief clamps to secure audio, power, and I/O cables attached to the Thor VM2 Dock.
1. Remove the strain relief clamp from the Thor VM2 by turning the screw counterclockwise. Put the screw aside in a safe
location.
2. Slide the strain relief clamp over the cable.
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the Quick Mount. Do
not stretch the cable. Leave enough slack in the cable to allow it to be connected and disconnected easily when needed.
4. Continue in this manner until all cables are secured to the Thor VM2 Dock.
4-16