External Power Supply, Optional; Connect External Power Supply - Honeywell Thor VM2 Reference Manual

External Power Supply, Optional

Note: The Honeywell-approved AC Power Supply and Adapter Cable are only intended for use in a 25ºC (77ºF) maximum
ambient temperature environment.
In North America, this unit is intended for use with a UL Listed ITE power supply with output rated 10 – 60 VDC, minimum
15W. Outside North America, this unit is intended for use with an IEC certified ITE power supply with output rated 10 – 60
VDC, minimum 15W.
The external power supply may be connected to either a 120V, 60Hz supply or, outside North America, to a 230V, 50Hz
supply, using the appropriate detachable cordset. In all cases, connect to a properly grounded source of supply provided with
maximum 15 Amp overcurrent protection (10 Amp for 230V circuits).

Connect External Power Supply

1. Connect the provided detachable cordset (US only, all others must provide their own cable) to the external power supply
(IEC 320 connector).
2. Plug cordset into appropriate, grounded, electrical supply receptacle (AC mains).
3. Connect the DC Output Cable end to the corresponding connector on the Adapter Cable.
4. Connect the watertight connector end of the Adapter Cable to the Thor VM2 Quick Mount Smart Dock Power Connector
by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten
securely.
5. Flip the power switch on the back of the Dock to On.
6. Press the Power button on the front of the Thor VM2.
4-14
1. AC Input Cable (US
only)
2. DC Output Cable
3. To DC Output Cable
(see above)
4. To Thor VM2