Cisco Headset 500 Series User Manual page 37

Headset Settings
Enable Electronic Hookswitch Control on Your Phone
If your administrator has enabled Admin settings on your Cisco IP Phone, you can enable or disable electronic
hookswitch control to connect with a Cisco Headset 560 Series base. Electronic hookswitch control is enabled
by default.
Note This feature is available on Cisco IP Phone Firmware Release 12.7(1) and later.
Procedure
Step 1
On your phone, press Applications
Step 2 Navigate Admin settings > Aux port.
Step 3
Select Connect e-hook headset to enable electronic hookswitch control.
Reset Cisco Headset Settings from Your Phone
You can reset your Cisco headset to remove your custom settings. This action returns the headset to the original
configuration set by your administrator.
Your phone must be running Firmware Release 12.5(1)SR3 or later for this feature to function.
Before you begin
Connect your headset to the phone:
• Cisco Headset 520 Series: Connect with the USB adapter
• Cisco Headset 530 Series: Connect with the USB cable
• Cisco Headset 560 Series: Connect the standard base or multibase with the USB or Y-cable.
Procedure
Step 1 On the phone, press Applications
Step 2
Select Accessories > Setup > Reset settings.
Step 3 At the warning window, select Reset.
Multiplatform Phone Headset Customization
After you personalize your headset settings, your phone saves your tuning selections and applies to them to
any future Cisco headset model you use.
Enable Electronic Hookswitch Control on Your Phone
.
.
Cisco Headset 500 Series User Guide
29