New And Changed Information; New Information For Firmware Release 2.1(1) - Cisco Headset 500 Series User Manual

New and Changed Information

Note You can't unpair the primary headset if you have an active call or are in conferencing mode.
Procedure
Step 1 On your new headset, hold Mute
Step 2
Place the headset on the base. The base designates the new headset as the primary headset and un-pairs with
the old headset.
The old primary headset plays a tone indication when it unpairs from the base.
New and Changed Information

New Information for Firmware Release 2.1(1)

Table 9: Cisco Headset 500 Series User Guide Revisions for Firmware Release 2.1(1)
Feature
The Cisco Headset 560 Series powers down if unpaired after 20
minutes to conserve battery power.
The Cisco Headset 560 Series can maintain call control with
multiple open call clients on the same computer.
Headset upgrade progress displays on the Cisco Jabber UI (Cisco
Jabber version 12.9 or later).
Enhancement to the Cisco Headset 560 Series Multibase
auto-switch feature.
Upgrade Through Cisco Webex Teams
Upgrade through the Cisco Headsets Web Tool
The Cisco Headset 560 Series conferencing feature is enabled by
default.
Cisco Headset 500 Series User Guide
16
for five seconds. The headset LED alternates red and white.
Updated Section
Cisco Headset 560 Series
Cisco Headset 560 Series
Update Your Headset Firmware on Cisco Jabber, on page 44
Answer a Call From a Different Source on the Multibase, on page
26
Upgrade Your Cisco Headset to the Latest Release on Cisco
Webex Teams
Upgrade Your Headset with the Cisco Headsets Web Tool, on
page 45
Cisco Headset 560 Series Conferencing, on page 12
Your Headset