New Information For Firmware Release 2.0(1); New Information For Firmware Release 1.5(1) - Cisco Headset 500 Series User Manual

Your Headset

New Information for Firmware Release 2.0(1)

Table 10: Cisco Headset 500 Series User Guide Revisions for Firmware Release 2.0(1)
Feature
Answer calls from a different source with the Cisco Headset 560
Series with Multibase
Report headset issues through Cisco Webex DX70 or DX80
Enable electronic hookswitch from your Cisco IP Phone
Cisco Headset 530 Series Y Trainer Cable

New Information for Firmware Release 1.5(1)

Table 11: Cisco Headset 500 Series User Guide Revisions for Firmware Release 1.5(1)
Feature
Headset Conferencing
Updated for added ringtones on incoming calls when you are
connected to a Cisco IP Phone
Updated for enhanced multibase Bluetooth capability
Updated for new headset settings in Cisco Jabber
Reset Cisco Headset Settings to the Administration settings
New Information for Firmware Release 2.0(1)
Updated Section
Answer a Call From a Different Source on the Multibase, on page
26
Report Headset Issues Through Your Cisco Webex DX Series,
on page 44
Enable Electronic Hookswitch Control on Your Phone, on page
29
Connect and Use the Cisco Headset 530 Series Y Trainer Cable,
on page 4
Updated Section
Cisco Headset 560 Series Conferencing, on page 12
Pair a Guest Headset, on page 14
Unpair a Guest Headset, on page 15
Change the Primary Paired Headset, on page 15
Unpair Your Primary Headset From Your Base, on page 15
Make and Answer Calls, on page 21
Make and Answer Calls, on page 24
Answer a Call From a Different Source on the Multibase, on page
26
Connect the Multibase to a Bluetooth Device, on page 11
Erase All Bluetooth Pairings, on page 12
Adjust Your Equalizer Settings in Cisco Jabber, on page 32
Adjust Your Sidetone in Cisco Jabber, on page 33
Reset Cisco Headset Settings from Your Phone, on page 29
Cisco Headset 500 Series User Guide
17