Cisco Headset 500 Series User Manual page 14

Cisco Headset 560 Series
The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 3: Cisco Headset 560 Series Buttons
Number Button
1
2
3
4 N/A
Cisco Headset 500 Series User Guide
6
Name Description
Power and Call button Use to power the headset on and off.
Press and hold for 1 second to power the headset on.
Press and hold for 4 seconds to power the headset off.
Incoming and active call management depends upon if you have one
call or multiple calls.
One call:
Multiple calls:
Mute button Toggle the microphone on and off.
Volume buttons Adjust the volume on your headset.
LED Shows the headset status:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to retrieve a
call from hold.
• Press twice to reject an incoming call.
• Press and hold to end a call.
• Press once to answer an incoming call and put the active call on
hold.
• Press once to put a call on hold. Press again to resume a call, or
press and hold until you hear a tone to end the current call and
to resume a held call.
• Press and hold until you hear a tone to end an active call, and to
answer another incoming call.
• Press twice to stay on a current call, and to reject a second
incoming call.
• Blinking red—Incoming call.
• Steady red—Active call.
• Blinking white—Firmware upgrade is in process or the headset
is pairing with the base station.
• Steady white—Headset is paired and properly seated on the base.
• Steady pulse—Headset is paired, in an idle state, and is off the
base.
Your Headset