3.
ABOUT THIS MANUAL
The number in the parenthesis () is the item number on the exploded diagram
4.
REPAIR
Repair the machine in accordance with "Instruction manual" or "Safety instructions".
4.1. NECESSARY REPAIRING TOOLS
Code No.
1R003
Retaining ring pliers ST-2N
1R028
Bearing setting pipe 20-12.2
1R030
Bearing setting pipe 25-17.2
1R032
Bearing setting plate 8.2
1R036
Bearing setting plate 17.2
1R041
Vise plate
1R164
Ring spring setting tool A
1R165
Ring spring setting tool B
1R207
45-degree Set square
1R208
90-degree Set square
1R258
V Block
1R269
Bearing extractor
1R285
Round bar for Arbor 11-50
1R291
Retaining ring S and R pliers
1R356
Bearing plate 10mm (for arbor press)
Description
1)
(Figure
(Figure
Use for
pulling off Pin 16-90 (155)
removing Ball bearing 6201DDW (55), press-fitting Spindle (56)
press-fitting Helical gear 53 (51)
removing Helical gear 53 (51)
press-fitting Spindle (56)
removing Rotor ass'y (25)
press-fitting Ball bearing 6201DDW (55),
removing Spindle (56)
removing Ball bearing 6201DDW (55)
adjusting the bevel angle to 45 degrees
adjusting the bevel angle to 90 degrees
removing Helical gear 53 (51)
removing Ball bearing 607DDW (48) and Ball bearing 629DDW
(28)
removing Helical gear 53 (51)
removing Retaining ring S-12 (49)
removing Helical gear 53 (51)
October 2015
2).
10 / 47