Assembling - Makita DLS714 Technical Information

4.4.7.2. ASSEMBLING

Assemble by reversing the disassembly procedure.
Be careful to check the points mentioned in
(46)
(93)
(94)
1 to 2 ㎜
Figure 57
(81)
(86)
Figure 57
Figure 58
Figure 58.
and
1. Be sure that Lock lever (86) moves smoothly.
2. In case it is hard to operate Safety lock mechanism,
adjust the position of Rod holder (81) by sliding it
parallel to Blade case.
3. Loosen two M4x10 Pan head screws (93) and slide Sub
lever (94) up or down to give a 1mm to 2mm clearance
from Safety cover (68) as drawn in the figure on the left.
And tighten the screws.
(68)
October 2015
30 / 47