Square Rod Complete; Assembling - Makita DLS714 Technical Information

4.4.10. SQUARE ROD COMPLETE

4.4.10.1. ASSEMBLING

(173)
(113)
(156)
(163)
(173)
(176)
(175)
(173)
Groove for Square rod
(163)
(156)
Figure 67
(164)
Threaded hole of
Turn base (Upper
side)
Threaded hole of
Turn base (Bottom
side)
(174)
Figure 68
Rubber pin
Axis of
Turn base complete
(156)
Figure 69
1. Pass Ring 26 (163) through the pipe of Arm holder
complete (156).
And then, assemble them to Turn base complete (173).
2. Align the hole of Ring 26 (163) to the threaded hole of
Turn base complete (173) (upper side), and fix them
with Compression spring 6 (113) and M6x28 Thumb
screw (164).
And then, tighten M4x10 Hex socket head bolt (174)
from the bottom side in the same way.
3. Slide Arm holder complete (156) so that the grooves for
square rod complete (175) come close to the axis of
Turn base complete (173). And then, secure Square rod
complete (175) to the pipes of Arm holder complete
(156) with two M5x30 Hex bolts (176).
Note: Rubber pin has to face the axis of Turn base
complete (173).
October 2015
34 / 47