Handle Section - Makita DLS714 Technical Information

6.1.3. HANDLE SECTION

Put Connector in this space as shown below.
Put Noise suppressor in this space as shown below.
Put Stator lead wires covered with a
tube in this groove.
Switch
Put Closed end splices in this space.
Handle R
Closed end splice
Battery fuel
gauge
Figure 88
Battery fuel
gauge
Controller
Do not route Lead wires on this boss.
• Route Lead wires connected to
Terminal B in this space.
• Put the slacking of Lead wires
connected to Battery fuel gauge in this
space.
Terminal B
October 2015
Terminal B
Terminal A
Handle L
47 / 47