Honeywell SmartVFD HVAC MR4 User Manual page 107

Honeywell • 35
3.5.4 Group 3.2: Start/Stop setup
Code Parameter
Remote control
M3.2.1
place
M3.2.2 Local/Remote
M3.2.3 Keypad stop button
M3.2.4 Start function
M3.2.5 Stop function
I/O A start/stop
M3.2.6
logic
I/O B start/stop
M3.2.7
logic
M3.2.8 AI1 start threshold
M3.2.9 Fieldbus start logic
Keypad Master
M3.2.10
Stop
Min Max Unit
0 1
0 1
0 1
0 1
0 1
0 3
0 3
3.00 100.00 %
0 1
0 1
Table 24. Start/Stop Setup menu
HVAC A
Default ID Description
Selection of remote control
place (start/stop). Can be
used to change back to
remote control from PC
0 172
e.g. in case of a broken
panel.
0=I/O control
1=Fieldbus control
Switch between local and
remote control places
0 211
0=Remote
1=Local
0=Stop button always
enabled (Yes)
0 114
1=Limited function of Stop
button (No)
0=Ramping
0 505
1=Flying start
0=Coasting
0 506
1=Ramping
CtrlSgn 1
0=Start fwd
1=Start fwd pulse(3-wire)
2=Start fwd pulse
3=AI1 threshold
0 300
CrtlSgn 2
0=Start fwd
1=Stop pulse (3-wire)
2=Start fwd pulse
3=AI1 threshold
0 363 See above.
If M3.2.6 (I/O Start/Stop
Logic) is set to value 3 (AI1
threshold) the motor will
start at the level set with
5.00 185 parameter this parameter
and stop at the same -2%
AI1 can also be used as
frequency reference at the
same time.
0=Rising edge required
1 889
1=State
0=Disable
1 1806
1=Enable
PPLICATION