Honeywell Elster EK280 Applications Manual page 73

EK280
Message Description, process
E2-HinwSig If an input has been configured as a signal input, this message will be displayed if
E3-HinwSig. an active signal has appeared at the corresponding terminal (e.g. terminal DE2).
E4-HinwSig. The input configuration can be adjusted using the configuration program "enSuite".
E5-HinwSig.
E6-HinwSig.
Remote clock The volume corrector has started to display its time via remote data transmission. It
will be deleted again once this has successfully been carried out.
If this message appears for more than several minutes, the function "Automatically
set time via RDT" is activated. However, if this does not work, please contact the
Elster support.
Cal.lock o. The calibration lock is open.
In normal operating conditions, the calibration lock should be closed to prevent
unauthorized changes.
To close the calibration lock, please go to
Admin.lock The administrator / customer lock is open.
Cust.lock o.
Bat. operat. The EK280 is in battery mode.
This signal is primarily used to inform a remote data transmission system that the
batteries run down more quickly during long periods of data transmission.
Dayl.Sav.Tim The time displayed in volume corrector is daylight saving time.
The switchover mode can be changed using the configuration program "enSuite".
Call Win.1 The specified call pickup time is active, i.e. the volume corrector will accept data
transmission calls.
Call Win.2
Call Win.3
Call Win.4
Call Win.5
Call Win.6
Application Manual
Ctrl.. St.PL and enter the value "0".
71