Fe260 Sim Card Insertion And Unlock - Honeywell Elster EK280 Applications Manual

EK280
6.3.1.2 EK280 jumpers
X6: No jumper
or one jumper on the pins located
near the terminals

6.3.2 FE260 SIM card insertion and unlock

The SIM card must only be inserted and if applicable unlocked in FE260 GSM/GPRS versions. For other
versions this chapter can be skipped.
SIM card installation varies according to the GSM/GPRS module used in the FE260:
• From around mid-2013: "ECM-GW-120" (see chapter 6.3.2.1)
• Older versions: Integra "M2106+" or "M2106B" (see chapter 6.3.2.2)
6.3.2.1 GSM/GPRS module "ECM-GW-120" (circa mid-2013 onwards)
a) SIM card insertion
Danger!
Ensure the mains voltage is disconnected before opening the FE260 housing, ensure it
is not turned back on and verify that there is no voltage.
Remove the four screws from the top of the FE260 and open it.
Push the metal bracket in the SIM card slot back halfway, and flip open the cover
Insert the SIM card into the card slot (in the lid), so that the gold contacts face downwards and the
beveled side is at the open end of the lid.
Figure 7: Modem and SIM card slot
Application Manual
X5: two jumpers
on the pins located
furthest from the terminals.
SIM card slot
Push the metal bracket:
Open
Close
ECM-GW-120 module
36