Honeywell Elster EK280 Applications Manual page 39

EK280
Click the lid shut again and gently slide the metal bracket outwards.
Screw the FE260 housing back on.
Finally, turn the FE260 power supply back on.
b) If necessary, unlock the SIM card (enter the PIN)
If the inserted SIM card's PIN ("Personal Identification Number") is activated, carry out the following
instructions to unlock it:
Move the cursor to the "Serv." tab in the EK280's display, then to
Interfaces > Terminal interface > GSM and GPRS > PIN
Press the ENTER
Move the cursor through the next digits using the
After entering the last digit press the
Under "P.Sta" the
If "P.Sta" is not displayed, move the cursor down using the
As soon as a communications time window is opened via the modem, the new PIN is used. After a few
seconds, under "P.Sta" the message
message "Pin Error" if the PIN was incorrectly entered.
6.3.2.2 GSM/GPRS module Integra "M2106+" or "M2106B"
a) SIM card insertion
Danger!
Ensure the mains voltage is disconnected before opening the FE260 housing, ensure it
is not turned back on and verify that there is no voltage.
Remove the four screws from the top of the FE260 and open it.
Ensure that the "JP2" (mode) jumper is in the "operation" position.
Press the button with for example a ballpoint pen or similar, to remove the SIM card slider.
Insert the SIM card into the card slot (in the lid), so that the gold contacts face upwards and the
beveled side is at the open end of the lid.
Figure 8: Modem and SIM card slot
Push the SIM card and slider back into the modem until the slider clicks into place.
Screw the FE260 housing back on.
Finally, turn the FE260 power supply back on.
b) If necessary, unlock the SIM card (enter the PIN), see chapter 6.3.2.1 section "b)".
Application Manual
key and enter the first PIN digit using the
ENTER
"Pin New" is now ready for confirmation.
"Pin
and
key and enter them.
key, to save the input.
arrow keys.
OK" is displayed if the correct PIN was entered, or the
arrow keys.
Jumper "JP2" ("mode") in
"operation" position
Integra M2106+
SIM card slot
Press the button to open the
SIM card slider.
GSM antenna connection
37