Table of Contents
Advertisement
GSMHS Installation and Setup Guide
Using the AlarmNet Direct Website
To program the module via the website (if you are already signed up for this service), go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx
If you are not signed up for this service, click on "Dealer Sign-Up."
Log in and follow the on-screen prompts.
Please have the following information available when programming the module:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on the outside of box and on label inside
module) or MIN number of the device you are replacing
After programming is complete, you must transfer the data to the module and the module
must be registered. Refer to Section 4: Registration, for further instructions.
Using a 7720P Programming Tool
Connect the 7720P Programming Tool as shown below. The GSMHS powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [Shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. Table 2-1 below
lists each normal and shift key function.
KEY
BS/ESC
/
N/Y
SHIFT
1/A
2/B
3-2
Figure 3-1. Cable Connections
Table 2-1. 7720P Normal and Shift Key (shift LED lit) Functions
NORMAL KEY FUNCTION
[BS]: Press to delete entry
[]: Scroll down programming
[N]: Press for "NO" answer
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
[1]: For entering the number 1
[2]: For entering the number 2
7720P
PROGRAMMING
JACK
Xmit
Shift
20 PROGRAMMING TOOL
A
B
C
BS / ESC
1
2
3
/
D
E
F
4
5
6
N / Y
S
T
X
7
8
9
Shift
Space
Enter
0
#
J1
BATTERY
CONNECTOR
SHIFT KEY FUNCTION
[ESC]: Press to quit program mode; also can reset
programming defaults*
[]: Scroll up programming
[Y]: Press SHIFT-Y for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
Advertisement
Table of Contents
