Gsm Status Displays; System Status Displays - Honeywell AlarmNet GSMHS Installation And Setup Manual

GSMHS Installation and Setup Guide

GSM Status Displays

[E]

System Status Displays

[S]
5-2
PriRSSI GPRS REG
-xxxdbm x x
Cntry Netw LAC
xxx xxx xxxxx
Cell BaseSt Chan
xxxxx x xxx
Second Site RSSI
-xxxdbm
ECP 67 TmPB Flt
xx 5 ++ OK
1234 67 TmPB Flt
5555 xx 5 ++ OK
GSM Status Display Screen 1
PriRSSI – Primary Site RSSI level in dbm
GPRS – GPRS Service availability where "x" can be:
"Y" if GPRS is available
"N" if GPRS is Not available
REG – Registration status from radio module where
"x" can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [Space] key to go to the next screen.
Press the backspace [BS] key to go to the last screen.
GSM Status Display Screen 2
Cntry – Country Code
Netw – Network Code
LAC – Local area code
Press the [Space] key to get to the next screen.
Press the backspace [BS] key to go to the previous field.
GSM Status Display Screen 3
Cell – Base Station ID
BaseSt – Base Station Antenna Sector
Chan – Control Channel in use
Press the [Space] key to go to the next screen.
Press the backspace [BS] key to go to the previous field.
GSM Status Display Screen 4
Secondary GSM Site RSSI level in dBm.
Press the [Space] key to go to the GSM Status Display
Screen 1.
Press the backspace [BS] key to go to the previous field.
ECP Mode
Displays the zone and system fault status.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
4204 Emulation Mode
Displays the zone and system fault status.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.