Programming The Module; Using The Alarmnet Direct Website - Honeywell GSMX Installation And Setup Manual

GSMX Installation and Setup Guide
6. Refer to the installation guide for the control panel, and complete the
ECP cable wiring.
7. Secure the wiring with ties as necessary.

Programming the Module

The GSMX requires an AlarmNet account. For new installa-
tions, please obtain the account information from the central
station prior to programming this module.
You can program the communications module by one of the following
methods:
•

Using the AlarmNet Direct website.

• Using the 7720P Programming Tool.
• Using the control panel's programming mode (for panels that
support this option) to access the communication module's
programming.
NOTE: The prompts in this document reflect use of the 7720P
Programming Tool.
Using the AlarmNet Direct Website
To program the module via the website (if you are already signed up for this
service), go to: https://services.alarmnet.com/AlarmNetDirect/
If you are not signed up for this service, click on "Dealer Sign-Up" and follow
the instructions. Log in and follow the on-screen prompts. Please have the
following information available when programming the module:
• Primary City ID (two-digit number), obtained from your monitoring
station.
• Primary Central Station ID (two-digit number), obtained from your
monitoring station.
•
Primary Subscriber ID (four-digit number), obtained from your
monitoring station.
•
Communications module MAC ID and MAC CRC number (located on
the outside of box and on a label inside the module).
After programming is complete, the module must be registered. Refer to the
Register the Module topic.
– 8 –