Table of Contents
Advertisement
GSMHS Installation and Setup Guide
PROMPTS
Program Device?
3
(Y/N)_
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)
Enter Password
6
Verify Password
7
Exit Prog. Mode?
8
(Y/N)_
Device Mode
9
(ECP)_
Important Information Regarding Primary Account (Questions 10-12)
Account information is provided by the central station administrator.
Primary City ID
10
(??)_
Primary CS ID
11
(???)
3-10
4204/
ZONE
ENTRY
2-4204
TRIG.
OPTIONS
[Y], [N]
To begin programming the module, press [Y]
and go to Prompt 9: "Device Mode."
To create a password if none has been
assigned, press [N] and go to Prompt 4:
"Create Password."
To change an existing password, press [N]
and go to Prompt 5: "Change Password."
[Y], [N]
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program
Device?" prompt.
If a password is desired, press [Y] and go to
Prompt 6: "Enter Password."
[Y], [N]
If a password has already been assigned, this
prompt appears after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
[0-9, A-F,
If [Y] was pressed in Prompt 4 or 5, this
N, S, T, X,
prompt appears.
Y]
Enter a 4-digit password (0-9, A-F, N, S, T, X,
Y).
[0-9, A-F,
Re-enter the password as confirmation.
N, S, T, X,
If the password doesn't match the first entry,
Y]
the following is displayed followed by the "Exit
Prog. Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
Exits program mode.
[Y], [N]
Press [N] to go back to Prompt 3.
[ESC]
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode para-
graph in this Section.
ECP
Press the [space] key to scroll through the
modes of operation.
Zone
Trig.
Press [ENTER] to select the mode of operation.
4204
See Table 2-2 for ECP mode programming.
Emu
Two
4204s
[01-99]
Enter the 2-digit primary city ID, 01-99
(decimal).
[01-FE]
Enter the 2-digit primary central station ID
number, 01-FE (HEX).
DESCRIPTION
Advertisement
Table of Contents
