Signal Strength (Rssi) / Mode And Status Leds; Mode And Status Indicator Switch - Honeywell AlarmNet GSMHS Installation And Setup Manual

Signal Strength (RSSI) / Mode and Status LEDs

The Signal Strength (RSSI) / Mode and Status LEDs normally display the module's signal
strength. LED 1 (red LED on the left) will be lit to indicate that the display is in RSSI mode,
and the other LEDs indicate signal strength (lowest to highest, from left to right) between
the module and the receiving tower.
 The signal strength RSSI LEDs will indicate regardless of whether the SIM is activated.
(If the SIM is not activated, the red FAULT LED will be lit).
 This allows you to immediately determine if the desired mounting location has sufficient
signal strength for proper operation.
 If the SIM is not activated, you can determine the signal strength by simultaneously
pressing the MODE and TAMPER buttons. For proper operation, look for at least 3 bars
lit solid.
R Y
NOTE: The module still must be activated and registered to transmit messages to AlarmNet
and your central station.

Mode and Status Indicator Switch

Press and hold the Mode and Status Indicator Switch to change the LED functions in order
to view the mode of operation and network carrier status. When the switch is held down,
LED 1 (red LED on the left) will be off, and the LEDs from left to right have the following
meanings:
Table A-2. LED Functions with Mode and Status Indicator Switch Depressed
LED 1
(red)
Off=Mode
and Status
indicator
See below for specific modes and status indications.
OPERATION MODE
ECP
Zone
4204
2 - 4204
RSSI Display
3 BARS MIN.
Y G G G
7845i-GSM-025-V0
Operation Modes (Table A-3)
LED 2
LED 3 (yellow)
(yellow)
Operation Operation Mode (in
Mode (in combination with
combination LED 2)
with LED 3)
Table A-3. Operation Modes
Status Indications (Table A-4)
LED 4
(green)
Not Used
LED 2
st
(1 yellow)
OFF
ON
OFF
ON
Appendices
LED 5 LED 6
(green) (green)
GPRS GSM
Service Module
Registration
with
Network
Carrier
LED 3
nd
(2 yellow)
OFF
OFF
ON
ON
A-3