Appendix C: Ip Downloading; General Information; Direct Wire Setup - Honeywell 7847i-E Installation And Setup Manual

Appendix C: IP Downloading

General Information

The 7847i-E can be used to provide high-speed up/downloading to Honeywell VISTA and
LynxR-I control panels. This allows site maintenance independent of central station
monitoring, and modification to sites through a Private LAN or globally via the Internet.
Residential panels that support IP downloading (e.g., Vista-20P and LynxR-I) are connected
to the unit through the ECP bus. Currently, commercial controls such as VISTA-128BP and
FBP support IP downloading through use of a Direct Wire connection (using the trigger
cable).
U L

Direct Wire Setup

To perform IP up/downloading using Direct Wire, the unit requires that Direct Wire
downloading over IP programming is enabled (Direct Wire Y/N), and that the ECP Device
Address on which the unit communicates with the control panel as a keypad is entered
(Keypad Address). Additionally, the 7847i-E must be connected by cable as shown below to
the panels listed.
NOTES:
1. For Direct Wire IP downloading on Commercial Fire panels (e.g. VISTA-128FBP,
FA1700C), Program Field 3*19 Enable J2 Header Printer Port must be set to "1".
2. This feature is not available if device is set for zone trigger mode.
3. If using the RS232 Home Automation features, you cannot use Direct Wire Downloading.
This includes customers using WinpakSE and ProWatch.
Downloading may only be performed if a technician is at the site.
Figure 16. Cable Connections for IP Downloading
C-1