Table of Contents
Advertisement
SHOCK HAZARD
•
•
•
•
Safety instructions for test-operation or repair
WARNING
•
•
•
CAUTION
R200
Isolated Analog Output Module 2MLF-DV4S, 2MLF-DC4S User's Guide
September 2010
Let the wiring be installed correctly after checking the voltage rated of
each product and the arrangement of terminals. If not, it may cause a
fire, electric shock or abnormal operation.
Secure the screws of terminals tightly with specified torque when wiring.
If the screws of terminals get loose, it may cause a short circuit, fire or
abnormal operation
Use the ground wire of Class 3 for FG terminals, which is exclusively
used for PLC. If the terminals are not grounded correctly, it may cause
abnormal operation.
Do not let any foreign materials such as wiring waste inside the module
while wiring. It may cause a fire, damage on the product or abnormal
.
operation
Do not touch the terminal when powered. It may cause an electric shock
or abnormal operation.
Prior to cleaning or tightening the terminal screws, let all the external
power off including PLC power. If not, it may cause an electric shock or
abnormal operation.
Do not let the battery recharge, disassemble, heat, short or solder. It may
cause injuries or fire, due to heat, explosion or ignition.
•
Do not remove PCB from the module case or remodel the module.
It may cause fire, electric shock or abnormal operation.
•
Prior to installing or disassembling the module, let all the external
power off including PLC power. If not, it may cause an electric
shock or abnormal operation.
Keep all wireless installations or cell phone at least 30cm away
•
from PLC. If not, it may cause an abnormal operation.
Honeywell
3. Installation and wiring
3.1. Before you begin
45
Advertisement
Table of Contents
