Electronics - Elevating Base (Bedded Models Only) - GE PANDA Service Manual

Chapter 4: Troubleshooting
Troubleshooting Tables
Possible Causes
Defective SpO
PCA or Control PCA
4.4.9.3 Oximetry System Failure
Possible Causes
Intermittent cables
4.4.10 Electronics – Elevating Base (Bedded Models Only)
4.4.10.1 No Motion
Possible Causes
Defective E-Base
No power to E-Base
4-40
Step Troubleshooting Procedure
3. If OK, remove the probe panel bottom cover.
Check the SpO
4.
SpO I/F PCA.
2
If OK, replace the SpO
5. good one from the Probe Panel Interface Board to
the SpO
2
I/F
2
6. If OK, replace the Control PCA or SpO
Step Troubleshooting Procedure
Check the connection between the Control PCA
1.
and Probe Panel Interface Board.
Check the connection between the SpO
2.
Circuit and SpO
Step Troubleshooting Procedure
Plug spare line cord directly into E-Base AC inlet.
1. - Green light ON indicates power to the E-Base.
- Test movement using foot switch pedals.
If no movement: remove E-Base shroud; verify
2. connectors from the foot switch pedals are
properly seated and connected.
If harness connections are OK and no movement
3.
from petals on either side, then replace E-Base.
With warmer powered, check for green light on
4. column (located next to AC inlet connector).
If not lit, continue.
Check settings in User Menu. If the E-Base is
disabled and user is unable to enable, check the
5.
Service Mode to ensure elevating base is enabled.
Change to enable and save settings.
If enabled and there is still no power, verify that
6. the E-Base power cord is connected properly to
EHBase AC inlet.
Rail Harness connection at the
2
Rail Harness with a known
2
I/F PCA.
I/F PCA.
2
Comments
I/F PCA.
2
Comments
For SpO
2
Flex Circuit part
2
numbers, refer to
section 6.9.
Comments
2.5 mm Hex
Wrench
Service Manual
Flex