Setting Up A Recording - Honeywell 30 Series Configuration Manual

Performance Series IP Camera Software Configuration Guide
•
Priority: Select the relative importance of this recording (High, Normal, or Low). Recording
with a higher priority setting will be executed first.
•
Source: Select a video stream as the recording source.
To enable recording notification, configure Event settings first, see
Note
Configuring Event Settings

Setting up a Recording

To set up a recording:
1. Select a trigger source.
Schedule: The server will start to record files on the local storage or network storage
(NAS).
Network fail: Since network fail, the server will start to record files on the local storage (SD
card).
2. Select a destination (SD or NAS) for the recorded video files. If you have not configured a
NAS server, see
•
Capacity: You can choose either the entire free space available or limit the reserved
space. The recording size limit must be larger than the reserved amount for cyclic
recording. The reserved space is a small amount of space used only for the
transaction stage when the capacity is about to be used up or recycled.
•
Enable cyclic recording: If you check this item, when the maximum capacity is
reached, the oldest file will be overwritten by the latest one. The reserved amount is
reserved for the transaction stage when the storage space is about to be full and new
data arrives. The minimum for the reserved space must be larger than 15 MegaBytes.
•
Recording file management: You can manually assign the Maximum duration and the
Maximum file size for each recording footage. You may need to stitch individual files
together under some circumstances. You may also designate a file name prefix by
filling in the responsive text field.
•
File name prefix: Enter the text that will be appended to the front of the file name.
If you want to enable recording notification, click Event to configure event triggering settings.
For more information, see
When completed, select Enable this recording. Click Save to enable the setting and click
Close to exit this page. When the system begins recording, it will send the recorded files to the
network storage. The new recording name will be displayed on the recording settings page as
shown below.
To remove a recording setting from the page, click Delete.
78
on page 60.
Adding NAS Server on page 79.
Configuring Event Settings on page 60.