Figure 3-11 1O (Original) Display Mode; Figure 3-12 1P (One Panoramic) Display Mode - Honeywell 30 Series Configuration Manual

Performance Series IP Camera Software Configuration Guide

Figure 3-11 1O (Original) Display mode

1P (One Panoramic) Display Mode
With the image correction algorithms in firmware, the hemispheric image is transformed into
a rectilinear stripe in the 1P display mode. You can use the PTZ panel or simply use mouse
drags to quickly move through the 360º panoramic view. (Mouse control on the Panoramic
view is available with the Ceiling mount type.)
When mounted on a wall, this mode can cover a 180º overview from side to side, e.g., on the
entrance of a building or a corridor.

Figure 3-12 1P (One Panoramic) Display mode

The 1P view is applicable for an overview, the Zoom in/out function
Note
does not apply in this mode.
14