Figure 6-11 Trigger Sources - Honeywell 30 Series Configuration Manual

Performance Series IP Camera Software Configuration Guide

Figure 6-11 Trigger Sources

Video motion detection
This option makes use of the built-in motion detection mechanism as a trigger source. To
enable this function, you need to configure a Motion Detection Window first. For more
information, see
Periodically
This option allows the camera to trigger periodically for every other defined minute. Up to 999
minutes can be set.
System boot
This option triggers the camera when the power to the camera is disconnected and re-
connected.
Recording notify
This option allows the camera to trigger when the recording disk is full or when recording
starts to overwrite older data.
Audio detection (Fisheye Model only)
A preset threshold can be configured with an external microphone as the trigger to system
event. The triggering condition can be an input exceeding or falling below a threshold. Audio
detection can take place as a complement to motion detection or as a method to detect
activities not covered by the camera's view.
Camera tampering detection
This option allows the camera to trigger when the camera detects that is being tampered with.
To enable this function, you need to configure the Tampering Detection option first, see
Configuring Tampering Detection Settings
Manual triggers
This option allows users to enable event triggers manually by clicking the on/off button on
the homepage. Configure 1 to 3 associated events before using this function.
Action
It defines the actions to be performed by the camera when a trigger is activated.
64
Configuring Motion Detection Settings on page 55.
on page 59.