Configuring Ieee 802.1X Settings; Figure 5-17 Ieee 802.1X Configurations - Eap-Peap; Figure 5-18 Ieee 802.1X Configurations - Eap-Tls - Honeywell 30 Series Configuration Manual

Performance Series IP Camera Software Configuration Guide

Configuring IEEE 802.1X Settings

Go to Setup Network Setup 802.1X.
IEEE802.1X is the access control and authentication protocol for local and metropolitan area
networks. It uses a port-based network access control protocol to restrict unauthorized user
and/or device access to the LAN. The network devices, intermediary switch/access point/hub,
and RADIUS server must support and enable 802.1x settings.
To configure IEEE 802.1x settings:
1. Before connecting the camera to the protected network with 802.1x, apply a digital
certificate from a Certificate Authority (i.e., your network administrator) which can be
validated by a RADIUS server.
2. Connect the camera to a PC or notebook outside of the protected LAN. Open the
configuration page of the camera as shown below.
Figure 5-17 IEEE 802.1X Configurations – EAP-PEAP
Figure 5-18 IEEE 802.1X Configurations – EAP-TLS
Select EAP-PEAP or EAP-TLS as the EAP method. Enter your ID and password issued by
the CA, and then upload related certificate(s).
3. When all settings are complete, move the camera to the protected LAN by connecting it to
an 802.1x enabled switch. The devices will then start the authentication automatically.
54