Configuring Digital Ptz Settings; Figure 4-16 Audio - Honeywell 30 Series Configuration Manual

Figure 4-16 Audio

Mute: Check to disable audio transmission from the Network Camera to all clients.
Internal microphone input gain: Select the gain of the internal audio input according to
ambient conditions. Adjust the gain from 0% (least) to 100% (most).
Audio type: Select audio codec as G.711 or G.726 and the bit rate.
•
G.711 provides good sound quality and requires about 64Kbps. Select pcmu (μ-Law) or
pcma (A-Law) mode.
•
G.726 is a speech codec standard covering voice transmission at rates of 16, 24, 32, and
40kbit/s.
After you complete the settings on this page, click Save to enable the settings.

Configuring Digital PTZ Settings

This section describes how to control the camera's digital Pan/Tilt/Zoom operation.
Within a field of view, it allows you to quickly move the focus to a target area for close-up
viewing without physically moving the camera. You are still able to digitally zoom and navigate
the camera's viewable area.
Go to Setup Camera Setup  PTZ Settings.
Configuring Camera Settings
37