Honda NSX-T 1998 Manual page 1082

Main Menu
Windshield
Installation (cont'd)
11. With a sponge, apply a light coat of body primer to
the original adhesive remaining around the wind-
shield flange. The windshield should be installed 10
minutes after you apply the primer.
NOTE:
• Do not apply glass primer to the body, and be
careful not to mix up glass and body primer
sponges.
• Never touch the primed surfaces with your
hands.
• Mask off the dashboard before painting the
flange.
12. Glue the upper fastener to the body as shown.
Table of Contents
13. Use suction cups to hold the windshield over the
opening, align it with the alignment marks made in
step 5 and set it down on the adhesive. Lightly
push on the windshield until its edges are fully
seated on the adhesive all the way around.
NOTE: Do not close or open the doors until the
adhesive is dry.
14. Install the upper molding.
ALIGNMENT MARKS