Wireless Indoor Sensor; Redlink Internet Gateway - Honeywell THX9321 Prestige 2.0 Product Data

Hide thumbs Also See for THX9321 Prestige 2.0:
Table of Contents

Advertisement

ERROR MESSAGES:
E1 29: Incompatible device cannot be connected.
E1 34: Low RF signal. Move device to a different location and
try again.
E1 38: Make sure the thermostat, EIM, or TrueZONE Wireless
Adapter is in Wireless Setup mode, and the Portable Comfort
Control is at least 2 feet away (600 mm).
NOTE: The linking procedure will time out if there is no
keypress for 30 minutes. To begin again, press
and hold in the lower right corner of the screen
until the display changes (about 3 seconds). See
Fig. 46.
Fig. 46. Restarting the linking process.

RedLINK Internet Gateway

1. Press and quickly release the button on the bottom of the
Internet Gateway. After a short delay, the RedLINK sta-
tus light will glow steady green.
Fig. 47. RedLINK Internet Gateway connect button.
NOTE: The Internet Gateway must be registered online
before use at www.mytotalconnectcomfort.com.
Enter the MAC ID and MAC CRC numbers located
on the bottom of the Internet Gateway. For addi-
tional information, see instructions provided with
the device.
THX9321 PRESTIGE
Press and hold
the blank space
(or arrow may be
present)
MCR32943
19
®
2.0 AND THX9421 PRESTIGE
TrueSTEAM
1. Press and quickly release the CONNECT button on
THM4000 Wireless Adapter. After a short delay, the
CONNECTED status light will glow steady green.
THM4000R1000
Fig. 48. Connect button on TrueSTEAM wireless adapter.

Wireless Indoor Sensor

1. Press and quickly release the CONNECT button. After a
short delay, the status light (see Fig. 49) will glow green
for 15 seconds. If the status light turns red, the sensor
did not link with the thermostat.
MCR32934
Fig. 49. Wireless indoor sensor connect button and status
NOTE: In normal operation, the status light remains off.
If it begins flashing red, batteries are low (power
will be depleted after 2–3 weeks).
2. If you are installing more than 1 wireless indoor sensor,
give each sensor a name as you install it. Press Name
Device, as shown in Fig. 50.
®
IAQ WITH EIM
TrueSTEAM
MCRXXXXX
MCR32935
light.
Fig. 50.
68-0311—02

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thx9421 prestige iaq with eim

Table of Contents