Cisco MDS 9000 Series Configuration Manual page 86

Displaying Interface Information
fc3/1
fc3/2
fc3/3
fc3/4
fc3/5
fc9/8
fc9/9
fc9/10
fc9/11
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
port-channel 1
port-channel 2
You can run the show interface transceiver command only on a switch in the Cisco MDS 9100
Series if the SFP is present, as show in the following example:
Displays Transceiver Information
switch# show interface transceiver
fc1/1 SFP is present
name is CISCO-AGILENT
part number is QFBR-5796L
revision is
serial number is A00162193
fc-transmitter type is short wave laser
cisco extended id is unknown (0x0)
...
fc1/9 SFP is present
name is FINISAR CORP.
part number is FTRJ-1319-7D-CSC
revision is
serial number is H11A6ER
fc-transmitter type is long wave laser cost reduced
cisco extended id is unknown (0x0)
...
The following example displays the entire running configuration, with information about all the
interfaces. The interfaces have multiple entries in the configuration files to ensure that the interface
configuration commands execute in the correct order when the switch reloads.
Displays the Running Configuration for All Interfaces
switch# show running-config
...
interface fc9/1
switchport speed 2000
...
interface fc9/1
switchport mode E
...
interface fc9/1
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
68
0 3871
0 3902
0 3901
0 3895
0 3890
0 0
0 5
0 4186
0 4331
Input (rate is 5 min avg)
-----------------------------
Rate Total
Mbits/s Frames
0 0
0 3946
Configuring Interfaces
0 3874
0 4232
0 4138
0 3894
0 3897
0 0
0 4
0 4182
0 4315
Output (rate is 5 min avg)
-----------------------------
Rate Total
Mbits/s Frames
0 0
0 3946