Cisco MDS 9000 Series Configuration Manual page 48

Port Monitor
lr-rx
lr-tx
timeout-discards
credit-loss-reco
t x - c r e d i t - n o t - a v a i l a b l e
rx-datarate
tx-datarate
t x - s l o w p o r t - o p e r - d e l a y
2
3
txwait
e r r - p k t - f r o m - p o r t _ A S I C
Error Pkt
from Port
err-pkt-to-xbar_
ASIC
Error Pkt
to xbar
e r r - p k t - f r o m - x b a r _ A S I C
Error Pkt
from xbar
1
tx-credit-not-available and TXWait are configured as a percentage of the polling interval. So, if 10%
is configured with a 1 second polling interval, the tx-credit-not-available will alert when the port does
not have tx credits available for 100 ms.
2
3
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
30
Delta 60 5
Delta 60 5
Delta 60 200
Delta 60 1
Delta 1 10%
1
Delta 60 80%
Delta 60 80%
Absolute 60 50 ms
Delta 60 40%
— — —
— — —
— — —
• For all platforms, if the default value for tx-slowport-oper-delay is modified, ISSD to a version
lower than Cisco MDS NX-OS Release 6.2(13) will be restricted. To proceed with ISSD, use the
no form of the counter tx-slowport-oper-delay command to roll back to the default value.
• This counter was introduced in Cisco NX-OS Release 6.2(13).
• For all platforms, if the default value for txwait is modified, ISSD to a version lower than Cisco
MDS NX-OS Release 6.2(13) will be restricted. To proceed with ISSD, use the no form of the
counter txwait command to roll back to the default value.
4 1 4
4 1 4
4 10 4
4 0 4
4 0% 4
4 20% 4
4 20% 4
4 0 ms 4
4 0% 4
— — —
— — —
— — —
Configuring Interfaces
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
Not Not
enabled enabled
— —
— —
— —