Cisco MDS 9000 Series Configuration Manual page 263

Configuring PortChannels
Step 6
Configure the PortChannel member interfaces on the NPV switch:
Example:
switch(config)# interface fc2/1-3
switch(config-if)# shut
switch(config-if)# switchport mode NP
switch(config-if)# switchport speed 4000
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport trunk mode off
switch(config-if)# channel-group 1
switch(config-if)# no shut
switch(config-if)# exit
Step 7
Set the administrative state of all the PortChannel member interfaces in both NPIV core switch and the NPV switch to
ON:
Example:
switch(config)# interface fc1/1-3
switch(config-if)# shut
switch(config-if)# >no shut
switch(config)# interface fc2/1-3
switch(config-if)# shut
switch(config-if)# >no shut
Configuration Examples for F and TF PortChannels
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
245