Configuring The Port Administrative Speeds; Configuring Port Speed Group - Cisco MDS 9000 Series Configuration Manual

Configuring the Port Administrative Speeds

switch#configure terminal
Step 2
Select a Fibre Channel interface and enter interface configuration submode:
switch(config)# interface fc 3/29
Step 3 Configure switch port mode E on the Fibre Channel interface:
switch(config)# switchport mode E
Ensure that you perform the task of setting the port mode to E on both the switches between which you are
Note
attempting to bring up the ISL link.
Configuring the Port Administrative Speeds
Note
Changing the port administrative speed is a disruptive operation.
To configure the port speed of the interface, perform these steps:
Step 1 Enter configuration mode:
switch# configure terminal
Step 2 Select the Fibre Channel interface and enter interface configuration mode:
switch(config)# interface fc 1/1
Step 3
Configure the port speed of the interface to 1000 Mbps:
switch(config-if)# switchport speed 1000
All the 10-Gbps capable interfaces, except the interface that is being configured, must be in the out-of-service state. At
least one other 10-Gbps capable interface must be in the in-service state.
(Optional) Revert to the factory default (auto) administrative speed of the interface:
switch(config-if)# no switchport speed

Configuring Port Speed Group

To configure the port speed group of the interface, perform these steps:
Step 1
Enter configuration mode:
switch# configure terminal
Step 2 Select the Fibre Channel interface and enter interface configuration mode:
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
46
Configuring Interfaces