Redundancy Tab - Honeywell Experion C300 User Manual

Plain Text
Module is redundant
Secondary Tag
Name
Advanced Configuration
Alarming Enabled
GPS Time Source
Enabled
Temperature High
Alarm (deg. C)
CPU Free Low Alarm
(%)
CPU Free Low Low
Alarm (%)

Redundancy tab

The Redundancy Tab displays redundancy-related information and allows redundancy
commands to be issued when the C300 FB is opened on the Monitor Tree in Control
Builder. The following table summarizes the parameter data you can monitor and/or
configure on the Redundancy tab of the configuration form for the selected C300 block.
See Redundancy parameters
Note that the Redundancy tab is exposed only when the Controller is configured as
redundant. The Module is redundant check box (MODISREDUN parameter) is checked
on the Main tab
R301.1
11/06
Parameter Name
MODISREDUN
SECMODNAME
ALMENBSTATE
GPSENABLE
(Currently not used)
OVERTEMPTHLD
CPULOLM
CPULOLOLM
also for further descriptions of these parameters.
of the C300 block.
Experion C300 Controller User's Guide
Honeywell
C300 Controller Block
User
Configurable
Project only Controller is part of
redundant pair
Project only System assigned name
based on tag name with
sec suffix for secondary
block.
Yes Allows user to set the
alarm reporting function
used when an alarm
condition is detected by
the function block.
Yes Allows you to select GPS
as TIMESOURCE for time
synchronization.
Yes Set threshold value for
module's temperature high
alarm.
Yes Allows user to set CPU
Free Low Capacity alarm
limit in percent.
No Fixed CPU Free Low Low
Capacity alarm limit in
percent
Redundancy tab
Notes
79