C300 Controller start up
C300 Controller states in boot mode
Figure 6 C300 Controller Startup and Boot Mode indications
C300 Controller states in boot mode
At the conclusion of POST, it determines whether or not there is a valid Application
Image present in the controller and whether it should then transition to executing this
Application image (Application mode) or to continue in the Boot mode.
If the controller remains in the Boot mode, the controller then enters one of the states
•
in Table 6 and joins the FTE network on which it resides. See Table 12 for a
description of the faceplate indications when the controller is operating in the boot
mode.
If the controller transitions to the Application mode, the controller then joins the
•
FTE network and enters one of the operating states described in Table 7.
Controller
State
ALIVE
160
Table 6 Controller in Boot mode
The controller determines that no application image exists or an
Experion C300 Controller User's Guide
Honeywell
Description
R301.1
11/06